Ignition fuse keeps blowing

Check out some similar questions!

92 accord ignition switch fuse [ 12 Answers ]

92 accord. Will not start. Main relay will not click. I trouble shot relay bench ck out of car cks good. When I do main relay ck with it in the car #6 I get no voltage when I go to start on the ignition sw. #8 I get no ground when going to start position. Could a bad icm cause this? Also on the...

No power to ignition module or PCM ignition fuse, any thoughts [ 1 Answers ]

It's a 2001, Pontiac, Grand am, v-6 3.4. with the key in the on position there is no power to the ign mod, f/p inj, and pcm ing. so naturally its no start. I'm not sure of the circuit , the wire diagram is a little help, any suggestions? Frustrated

E fuse in Carrier gas furnace keeps blowing. Should a different fuse be used? [ 1 Answers ]

E fuse in Carrier gas furnace, model 58MCB, keeps blowing. Should a different fuse be used, or is the problem likely in a component.

Blown ignition fuse [ 3 Answers ]

I have a '95 GMC Suburban. It blew the 30 amp ignition control fuse. I swapped a 40 amp spare I had w/ same result. No idiot light in the instrument cluster show up until a new fuse is inserted. There was no warning of any pending trouble. It ran great. It has a new starter, alt, battery installed...

Keep blowing fuse [ 1 Answers ]

1998 Dodge Ram, been sitting for about a week, went to turn on windshield wipers and they didn't work. Check the fuse and it was blown. Changed fuse and as soon as I put it in the fuse blows. Did this several times and no luck. ANY IDEAS! THANKS,

View more questions Search

Check out some similar questions!

Add your answer here.