Ask Experts Questions for FREE Help !
Ask

Search:

Type: Posts; User: pipemaster17

Search: Search took 0.00 seconds.

  1. Answers
    1
    Views
    392

    Does anyone have any idea at all? Thanks

    Does anyone have any idea at all?
    Thanks
  2. Answers
    1
    Views
    392

    Ge oven temp off

    I have a nine year old ge oven that is 30 derees to cool and it doesn't have the adjustment on the knob. Can someone advise me how to adjust the oven? Model jbp766v3wn.

    Thanks,
    Pipemaster17
  3. Washer only filling 1/2 full on rinse cycle

    I have a coin-op washer model CA2742TQO that only fills 1/2 full on the rinse cycles, but fills full on the wash cycle. Any suggestions?
  4. Answers
    2
    Views
    3,093

    Yes, there is a mounting bracket you need. Find...

    Yes, there is a mounting bracket you need. Find your closest appliance parts store and the will show you a diagram.
    Pipemaster17
  5. Answers
    1
    Views
    1,294

    You have to place a putty knife under the lid...

    You have to place a putty knife under the lid approximately three inches in from each side and push hard and lift top. If you look into the crack between the lid and body of dryer you should see the...
  6. I'm sorry, I thought it was a Whirlpool built...

    I'm sorry, I thought it was a Whirlpool built Sears, not just a Whirlpool so that's why I said if it starts with 110. The repair would be the same, the model # would start differently.
  7. Is there a hole in the lid for the switch? If so...

    Is there a hole in the lid for the switch? If so is there two little holes along side the hole for screws? If this is the case your switch has come unscrewed. It is replaced by taking the whole...
  8. This unit should pump out first before it spins....

    This unit should pump out first before it spins. If it doesn't it would eventually burn up your clutch . By opening the lid you are activating the spin before it has emptied. This unit stops for a...
  9. Approximatley how old is this machine?

    Approximatley how old is this machine?
  10. Answers
    1
    Views
    1,702

    Has anyone changed the ignitor? Sometimes they...

    Has anyone changed the ignitor? Sometimes they glow too weak to ignight the gas. The gas only comes out for a second because there is a sensor to detect heat and if there is no ignition, it shuts...
  11. Answers
    1
    Views
    559

    Try opening the door and press the light switch...

    Try opening the door and press the light switch that the door makes contact with when it's closed. Hold the switch for about ten seconds. Sometimes the door gets opened before the clean latch is...
  12. Answers
    0
    Views
    520

    Oil filter cross reference

    Does a Fram oil filter PH5 cross to Champ PH25?
Results 1 to 12 of 12