 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I want to decrease the clamping force of the cylinder by reducing pressure without di
In my fixture two operation to be done. Milling and boring in vertical CNC machine.
Sequence of operation is 1.Clamp the cylinder in 30 bar (900 kg force) 2.milling operation. 3.bring down the clamping cylinder pressure to 10 bar (300 kg force) without disturbing the clamps. 4. boring operation. How to design the hydraulic circuit. |
||||
Check out some similar questions!
Which cylinder is the number 1 cylinder in a 4 cylinder 1997 toyota camry?
The water pressure in my kitchen has been cut in half. But the rest of the house the pressure is fine. What should I do?
We have a 3 year old home with copper plumbing. We had no problems until we recently installed a mud room with a sink. We suddenly lost hot water pressure at the kitchen sink. All the other faucets throughout the house have pressure, and the cold water pressure at the kitchen sink is fine and...
Hi there We have recently installed a new caresse combined shower/bath mixer with diverter. The hot water flows OK when the mixer is turned to hot and the cold water has a much higher pressure when just on cold. The problem is when we try to get warm water the mixing valve makes a louder noise...
When you turn on the hot water the faucet runs fine for about 15 seconds, then the pressure decreases. What could cause this?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
