 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
How to I get the hook of my model gantry to traverse over and back
I am after building the frame of a model gantry crane out of 12mm diameter brass bar and for that reason I can not use my rack and pinion idea and am really stuck in trying to find another way to make the hook move over and back. Also the hook goes up and down using a motor and the motor is resting on a piece of plastic which also which is really all that moves like one big block to move from one side of crane to the other the distance from end to end of crane is about 350mm really appreciate any help
|
||||
|
||||
|
After 24 hours have past post a pic using Go advanced/manage attachments
I was involved in building a Gantry Crane which was featured in a magazine. Here are the pics of the Gantry. It was the second generation. This was before the IBM PC. It was computerized with a SBC (Single board computer) The gantry had 4 fixed positions and potentiometer feedback for the up/down of the electromagnet. This was turned into two positions with the electronics. The black gizmo in the car is a 10 turn pot. Under it is a gear reduction motor. There is two rows of a sliding contact on a gold plated circuit board. One of the traces was not continuous. It connected via a 10 conductor coiled cord. The other part of the gantry had 9 positions. This thing was about 4' x 6'. It was capable of loading and unloading 27 pieces of cargo to a loading dock at the push of a button. Dynamic breaking was also employed. The larger gantry used a precision rod and a couple of linear bearings. It only had to rest and ride at the extreme edge, so it just needed and idler. |
||||
|
||||
|
The long Gantry has to really consist of at least one pair of linear bearings and one piece of precision shafting. See: LM76 Linear Bearings & Linear Shafting & Linear Motion Slides Precision shafting is held to tight tolerences. Friction can be an issue with hobby motors. The far end just needs an idler because gravity holds it down depending on how much the short gantry weighs. Movement can be done with ladder or bead chain with the ends secured to the gantry. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
i have a g.e. weatherton merury thermostat model- 3aat80a1a1 am replacing it with abreburn model-2200 digital thermostat multi-stage 2-1 the 3aat80a1a1 is wire up this way ( red wire -r) (orange wire-o) (brown wire-t) (green wire-g) ( yellow wire-y) ( black wire-x2) ( blue wire-b) ( u-w have a...
I had a traverse hearing in NYC yesterday. The judge did not dismiss the case even though the processing server was not there. What he did decide was for the collections lawyer to prepare an opposition to the motion within two weeks and for me to write in letter to him why I feel this case should...
Dear sir/madam, Many kind of crane rails are available in market. But how to choose the correct rails for the following crane. Crane maximum weights is 20000kg and safe working load is 50000kg. There are 4 steel wheels which the diameter 2ft, width of wheel 10cm.
Please find me a diagram on how to hook up my thermostat. The model # is 1f78. If you could assist me in this matter, I would be very grateful. Thanks! Eddie P.
I am trying to hook up a Honeywell RTH7000 to a whalen unit Model # W602E. The wiring diagram has faded to the degree of partial readability. The unit has 6 wires red, blk, brn, yellow, blue, orange I have: red to R Blk to C Brn to G (fan) Yell to Y1 ...
View more questions Search
|
