Ask Experts Questions for FREE Help !
Ask
    Akshay0402's Avatar
    Akshay0402 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Dec 28, 2017, 10:45 PM
    Design of a gauges and fixture
    I want a complete guide for designing gauges and fixture for a part with tolerances.

    Sent from my Mi A1 using Tapatalk
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Dec 29, 2017, 10:59 AM
    This could be anything from designing interplanetary spaceships to a shut off valve in a water heater. Care to expand a bit?
    Akshay0402's Avatar
    Akshay0402 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Dec 29, 2017, 06:27 PM
    I want to design it for front hub

    Sent from my Mi A1 using Tapatalk
    talaniman's Avatar
    talaniman Posts: 54,327, Reputation: 10855
    Expert
    		  
    #4

    Dec 30, 2017, 05:55 AM
    Front hub is a reference to wheel bearings, so if you could be a lot more specific maybe we can help. The more information the better. A drawing picture would be great.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #5

    Dec 30, 2017, 02:53 PM
    Most fixtures for hub measurements are available today. I have used them for rotor and hub alignment on front ends. Run out gauges are commonly available and use magnets to hold them on.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Is Vancouver College of Art and Design a good school to study Graphic Design? [ 1 Answers ]

Hi everyone I am currently looking into VCAD for their Graphic Design program. I have heard mixed reviews and I am hoping one of you could tell me if it's a good school, and how the program was? Here are some more questions: - Did you feel the program prepared you for the Graphic Design industry...

I have heard that contextual design is a great design methodology. However, I am al [ 0 Answers ]

I have heard that contextual design is a great design methodology. However, I am also hearing discussion of design thinking. Are these design methodologies different or similar. Any thoughts are appreciated.

How to change a pull chain fixture to a fluorescent light fixture with a switch ? [ 1 Answers ]

I would like to install a switch for a pull light fixture. The only power is from the light fixture, but I want to put a light switch on the wall as I enter the room, Can you help ?

Plastic Product design, Mold design, Plastics, [ 2 Answers ]

What are all the precautions needs to be taken during Nylon molding?

View more questions Search