Ask Experts Questions for FREE Help !
Ask
    tony42's Avatar
    tony42 Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 15, 2010, 05:30 PM
    A beam with 2in by 3 in cross section is supporting 1000 pounds what is the stress
    A beam with 2in by 3 in cross section is supporting 1000 pounds what is the stress on the beam
    ROLCAM's Avatar
    ROLCAM Posts: 1,420, Reputation: 23
    Ultra Member
     
    #2

    Feb 15, 2010, 06:33 PM

    The stress is 166.66 pounds per square inch.
    ebaines's Avatar
    ebaines Posts: 12,131, Reputation: 1307
    Expert
     
    #3

    Feb 18, 2010, 07:10 AM
    Quote Originally Posted by ROLCAM View Post
    The stress is 166.66 pounds per square inch.
    You might be correct, but then again you may not be. We just don't have enough information from what the OP posted to solve this problem. If the beam is acting purely as a column that is bearing a load of 1000 pounds, then yes - its cross section of 6 square inches is supporting 1000 pounds weight, for 166 PSI (assuming the beamn itself is weightless). However, we don't know if that is how its being used. If the beam is spanning between two simple supports (like a floor joist), or is cantilevered from a wall supporting a weight (like a diving board), then the stress varies with position along the length of the beam. So to answer this question we need more information, such as the length of the beam, its cross-section height and width, the point where the load is applied, and the method of support of the beam.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

O.5 C charge passes through through a cross section of a conductor in 5s?find the cur [ 1 Answers ]

o.5 C charge passes through through a cross section of a conductor in 5s?find the current

Termite damage in beam supporting floor joists [ 2 Answers ]

Termites got into the end of a beam supporting the floor joists in a crawl space under the first floor. I think I can use floor jacks and termporary beams on either side of the damaged beam to support the floor, then cut our the damaged beam. It is about 8 ft from the concrete foundation wall to...

How big of a beam should I use for a supporting wall? [ 1 Answers ]

Dear Ask Me Help Desk, I am renovating my kitchen (see related threads on water flow and gas lines in plumbing) and need help on calculating the size of a beam for a supporting wall. I live in L-Shaped 2900 square feet 1963-built rancher in Atlanta, GA. The kitchen is on one side of a long run at...


View more questions Search