Ask Experts Questions for FREE Help !
Ask
    rbsdkp's Avatar
    rbsdkp Posts: 3, Reputation: 1
    New Member
     
    #1

    Mar 10, 2008, 10:54 AM
    shower pan curb
    Does a showerpan curb need to be poured sand mix or can you just frame with 3or4 2x4s and wrap with membrane and durrarock? I am going to put a bench in the stall. Does the membrane have to go up the bench face then on the seat and up the stall 6 to 8 inches?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    Mar 10, 2008, 12:45 PM
    You do not use Durorock on the floor of a shower. Take a quick read of this fellows approach to building a shower pan. How to Build a Shower Pan

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

New Tiled Shower - cracked grout between shower wall and pan [ 4 Answers ]

I just spent 10K on labor alone to remodel my master bath. I purcahsed all Hand made tiles (Walker Zanger) and the contractor came highly recommended... After less than one month of use (and I did seal the shower walls and floor with a very good sealer), I noticed a hairline crack in the Grout...

Custom shower stall curb [ 1 Answers ]

how do you form the curb for a mud set shower stall? Is it just 2x4s stacked and wrapped with membrane and durarock, or do you have to pour the curb with the first layer of mud and then wrap it and pour a second layer higher?

Removing drain assembly from shower, relacing shower pan [ 1 Answers ]

How do I remove part of the old drain assembly that has been glued to the drain pipe that comes up from the slab floor.

My shower drain is raised above the shower pan by 3/16" causing standing water [ 2 Answers ]

I have a fiberglass shower stall where the bottom has either slumped or the stall was installed wrong to begin with (it has no support beneath the surface that I stand on). The drain sticks above the level line so I have about 3/16" of standing water. I cannot easily access the bottom from the...

Shower door and curb [ 1 Answers ]

I have a shower, with a swing out alumax shower door, the sweep feel apart. The bottom of the shower door enclosure has been leaking. The top of the curb Is a clay or cement material which is wet. The wall board below the is wet and the tlie has Fallen off. What do I replace the clay...


View more questions Search