Hello. I have a lot of molding to install throughout my home. Baseboards, door trim, crown molding, and quarter round. I have an air compressor and am going to get a nailer to put up all the molding. I'd like to get just one nail gun. Will a 16 gauge finisher do the job for all the moldings? The baseboard is pretty thick and I have to use the larger 11/16 quarter round due to gaps on the floor.

My concern is the finishing nailer might split the quarter round. But it is on the thicker side, and I think brads would be too light for the baseboard.

Any suggestions on the nail gun to get?

Thank you.