Ask Experts Questions for FREE Help !
Ask
    mmlb's Avatar
    mmlb Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jun 30, 2008, 07:52 AM
    How do I get my panel to send signal
    HI,
    I have a DSC 832 panel. I cannot get the system to send signal to the monitor station. I have phone dial tone at the panel. When the system is in test and the alarm is triggered the monitor station says them do not receive signal.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #2

    Jul 2, 2008, 01:15 PM
    Great Panel, Hopefully it has an RJ 31X Jack for Line seizure.(Keeps other phones from stopping communication between central station receiver), and wired correctly. I don't have Manual in front of me, am sure you have one, Be sure Account number, communication format, Central station number entered correctly. Try the same receiver number on a regular phone to verify you don't need to add a 1, area code or what ever, A telephone test set to verify tones are generated and a response would be nice.
    In the 832 programming be sure to have communication enabled(location 380/option 1), and might as well enable telephone line monitor to show trouble when phone goes out(intentionally or otherwise(Location 015/option 7).
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Updating service panel to 200 amp with feeder to 100 amp panel in old house [ 8 Answers ]

I currently in the process of converting 1000 sq ft of attached garage into living space while doing this we are updating electrical service to 200 amp new service, there is 100 amp service in the old part of the house which will remain but need to be sub paneled from the new 200 amp service. I...

Wiring from my house panel to my pole barn panel [ 1 Answers ]

I am going to be wiring my pole barn up soon and just need some help on the type of wire to use. In my house I have a 200 AMP service and plan on running a 100 AMP feeder from that panel to my subpanel in the barn. (Just under 100 Feet) I am going to run a 6 gauge ground, two 4 gauge...

Max Amps in a Panel and adding a sub panel for more circuits [ 3 Answers ]

Hello all, I recently moved into a condo with a 200 amp panel (in my unit). The main panel is in the electrical room of the building and my unit was previously a commercial retail space. I did some remodeling and my panel is now full. The total combined amps of all the circuit breakers...

Breaker size in main panel to support sub panel? [ 7 Answers ]

Hello, I am wiring a sub-panel to the outside of my home (50 feet from main 200 amp box). I ran 3 wire - 6 gauge. What is the largest 2 pole breaker I can put in the main panel to supply the sub-panel. TYPE NM-B 6-3 WITH GROUND 600 VOLTS CIRTEX-I EZ-STRIP (R) PLUS 17:11 2/5/07 SB/RC ...

View more questions Search