 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Dsc 1832 stay arm does not work
Hi:
I have a used DSC 1832 system and an RFK5501 keypad installed in my home. After reviewing instruction, I programmed it and it worked fine except, I could not make it work in Stay Arm mode. If I pressed the Stay Arm button for a few seconds and released it, the keypad screen went blank, and if I entered the master code after it, the Away Arm mode is active. I wonder if I missed anything in programming. I also wish to make system call my cell phone if any zone is violated when I am away. Your advice is greatly appreciated. |
||||
Check out some similar questions!
Where can I purchase the DSC brand of products of security systems.
Hi…I am currently replacing an old DSC PC 2525 home security system with a newer PC 1832. The trouble is… I am having difficulty even getting to first base programming this unit Is there someone on board who can walk me through this? This is what I have: 2 new keypads.. a pk 5501 at the...
I installed and programmed a new 1832 panel. I set delay 1 at 30 sec, delay 2 at 45 sec and exit delay at 60 sec. The zone is set at delay 1. The exit delay works fine, but I get no entry delay at all. Alarm goes off as soon as the door is opened. Any ideas?
Recently I have installed dsc 1832 security system . So far I have done good. But I can not solve my smoke detector problem . Smoke detector is FSA-410BT 4-wire . I have run cat5 wire for this connection . The reason is simply - I had left over cat5 . I have used Bro for 12v+ and BLU for GND....
I have a DCS 1832 and I am getting intermitting open. The wires at the control panel are tightly secured. It could be a resistor problem and I am unsure of to what the resitor value should be for the zones. Can you help?
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
