 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I want to install a light over my dinning table but there is no electrical to hand it
There is a handing light from the sealing about 8 feet away and I also have plug in at the bottom of the wall where the dining room is. Can I run electricity from either of these?
|
||||
Check out some similar questions!
Trying to find out where is was made and if it is worth anything.
Our vanity light consists of a long row of 6 bare bulbs with a metallic coverplate stretching a total of about 4 feet. We're replacing it with a newer, more modern light kit. I removed the old light and found there was no electrical box in the wall. The old light kit was instead secured by two...
I would like to replace an existing celling light with a Non-IC rated recessed can light. My house (built in 1984) is wired with 14/2 gauge w/ground Romex wire. The manufacturer’s instructions (UltiTech) state the following: Warning – Risk of fire. Most dwellilngs bilt before 1985 have their...
When I disconnected my swag dinning room light to change out shade I realize there is a thin wire that runs beside the lamp wire in the chain that I do not know what to reconnect it to, I am not sure if this is a wire used to support the fixture, it all sort of came down at the same time and I did...
The end of the run 12-3 wire coming from my upstais 3 way light is currently attatched to a single switch. I want to install a double gang box at that switch and feed power to 12/2 wire, through the switch that will power my dinning room light, that will run up to my dinning room light. In theroy I...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
