Check out some similar questions!

dewaltman · Jun 21, 2008, 09:01 PM

I have a 27" tv with a 2" horizontal line at the top then directly below it for about 5" there are a lot of horizontal white pin lines. Any ideas?I am an appliance technicial, so I can read a diagram and trace curcuits if necessary.

KISS · Jun 21, 2008, 10:09 PM

Horizontal output is dying and you have less high voltage, so the retrace lines are showing. You could just try replacing the Horiz output transistor although lots of things can cause this.

Credendovidis · Jun 24, 2008, 02:36 AM

If the problem was in the horizontal output stage, there would not be much (or little) to see (as the horizontal output also delivers the high voltage for the display) and the displayed lines would be vertical.

The problem is in the vertical output stage and is - reading your description - most probably in the connected suppression circuit that should interrupt the display during the short moment of vertical fly back.

First get a service manual. If you don't have one try any of the following Sears links :

Sears on-line website

http://www.sears.com/Service

http://www.searspartsdirect.com/partsdirecta

http://www.searspartsdirect.com/partsdirectb

===

Repair : look in the circuit that powers the first grid of the display tube. Brightness control is almost always connected to this grid. On top of that DC signal there are negative pulses for suppression of horizontal and vertical fly back signals. The problem is in the circuitry between the grid and the vertical output stage where vertical pulses should be passed on, but which fails to do so on this moment. Often that is due to either a failing capacitor or switching transistor.

If you have - or can borrow - an oscilloscope : use that. Start from the grid and go backwards towards the vertical output stage to find the problem.

Note : if your television is not a tube type, but LCD, there is little you can do yourself : bring it to a television repair shop ! Normally they do not repair the fault, but replace the motherboard , solving the problem - at quite a cost...

Success!
As always : if you require more info, please let me know. If this solves your problem, please rate the answer provided! Feed back is always appreciated!

;)