Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
York Diamond 80 - 7 flash error code
[ 1 Answers ]
I have a York Diamond 80. Will not light. Have done some research on here, cleaned the flame sensor, still no luck. Failed to ignite and locks out after three tries. What is the next step. What do I check? If anyone can help, great. Thanks
York furnace flash error code 6 times (blowing cold air)
[ 3 Answers ]
Hello, I have a York (forced air) gas furnace that's 9 years old. Every winter it seems like I have to replace the pressure switch ( round switch with 2 connections & air hose). I hear the blower come on, burners ignite and then within a few seconds they go off with the red light flashing 6 times....
Error code for "open pressure switch" on York natural gas furnace
[ 6 Answers ]
I get three red flashes from the furnace after an attempt sequence when the t-stat calls for heat. The motor starts, and seems to try to light but after about thirty seconds, it quits and gives the error code. I have removed both gray tubes from the pressure switch and made sure they are...
York Diamond 80 not lighting completely
[ 4 Answers ]
Hello, I have a York Diamond 80 furnace that was installed new in 2001. My problem is that the Heat exchanger will not fully light and stay on. The ignitor works fine but when ignition begins only the two burners closest to the ignitor ignites. The two will burn for a few seconds then go...
York Diamond 90
[ 1 Answers ]
I have a york diamond 90 and I have 4 code show what could it be View more questions Search
|