Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Propane Furnace won't start no pilot light red light flashes 3 times
[ 6 Answers ]
My propane furnace G6RC has no visible flame and the red light either stays on or flashes 3 times in a row and then the furnace shuts off and tries to restart
York board flashes 5 times
[ 10 Answers ]
York gas apck model #D3GA024N04206A fan runs continuously even with thermostat off unless I pull the power but will not ignite. Board is flashing 5 times. The small fan that runs to pull the gases out before ignition is running and I have air coming through the house vents, just no ignition and no...
Older York furnace's board flashes 4 times, blowers run, no heat
[ 14 Answers ]
When calling for heat and turning the furnace on, the inducer and main blower start immediately. The igniter doesn't glow. Code implies high temp limit switch is open. I took out the temperature gauge that is juat behind the gas valve (in the plenum) and it shows 0 resistance.
What does in mean when the error light on my york furnace flashes 12 times?
[ 0 Answers ]
Counted numerous times to make sure its 12 times. The chart that tells you what the fault codes mean does not go up to 12, it stops at 11. I induced a twinning error to rule that out as a rapid red flash. It does this every 1-2 days. I can get it to run for that long and then it does it again. ...
I have a York gas furnace and my error light flashes 8 times. What does this mean?
[ 0 Answers ]
York gas furnace LY85100B12UH11B View more questions Search
|