Ask Experts Questions for FREE Help !
Ask
    gary87's Avatar
    gary87 Posts: 1, Reputation: 1
    New Member
     
    #1

    Oct 30, 2008, 11:59 AM
    Wiring a Honeywell Pro 3000
    I need help with wiring colors. The Terminal designations are

    E AUX Y G O L R B C

    I HAVE A HEAT PUMP

    I GUESS I TRYING TO ASK WHAT WIRE GOES WERE.

    THIS IS WHAT I HAVE

    E-WHITE
    AUX-BLACK
    Y-YELLOW
    G-GREEN
    O-ORANGE
    R-RED
    C-BLUE


    HELP PLEASE:confused:
    kgmercier's Avatar
    kgmercier Posts: 7, Reputation: 1
    New Member
     
    #2

    Mar 8, 2010, 03:43 PM

    Did you get your answer? I am having a problem with the same t-stat, only my fan comes on 5 minutes after the t-stat reaches room temp and the fan stays on to repeat the cycle again.
    Missouri Bound's Avatar
    Missouri Bound Posts: 1,532, Reputation: 94
    Ultra Member
     
    #3

    Mar 8, 2010, 05:39 PM
    Both of you, look at the "sticky" at the beginning of this forum from Northern Heat. Detailed explainations are given for thermostat wiring and wire colors. Start there and if that doesn't help please post again.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Honeywell thermostat wiring [ 5 Answers ]

I've seen similar questions, but I need exact instructions. My old thermostat is wired as follows: W-Blue wire G-Green wire R-Red wire C-White wire Y-Yellow wire New thermostat has: Rh

Honeywell wiring [ 1 Answers ]

My heater wire was cut and i wrapped it with electrical tape but after a time the wire gets hot and melts the tape, so i found another cord like it but i forgot which wire hooked to what except the ground wire now the heater light comes on but no heat is there somewhere i can get a look at the...

Honeywell wiring different from old thermostat wiring [ 2 Answers ]

I purchased a non-programmable digital thermostat to replace an analog thermostat with wiring red, white yellow and black. How do I match the wiring? HELP!!

Replacing Honeywell T8411R with Honeywell RTH7500 - wiring problems [ 1 Answers ]

I need help getting my new, programmable thermostat to work. I currently have a dual-stage Heat Pump and A/C unit that works fine. The current thermostat is the Honeywell T8411R. I don't know the number for the subbase, but it's the one that came with the thermostat. The current (operational)...

Honeywell t8624d wiring [ 8 Answers ]

I am trying to replace my old honeywell thermostat with a new Honeywell t8624d Chronotherm IV. My old thermostat is the round turning type. I just want to use my new one for a 1 zone heat in basement. There is a red and white wire coming out of the wall. The red is going to the valve and the white...


View more questions Search