Ask Experts Questions for FREE Help !
Ask
    KAG123's Avatar
    KAG123 Posts: 2, Reputation: 1
    New Member
     
    #1

    Feb 10, 2011, 07:38 PM
    Why would the pilot light go out and where is it located?
    On a rheem furnace, model#3302-77 and serial#089edpn4e, wher is the pilot?
    T-Top's Avatar
    T-Top Posts: 1,871, Reputation: 100
    Ultra Member
     
    #2

    Feb 11, 2011, 08:42 PM
    That's not the full and or correct model# you gave. A standing pilot flame sets right in front of the burner or burners. If it's a standing pilot the thermocouple may be bad. Some old rheem units used mercury flame sensors that would plug on top of the gas valves.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I cannot find the button to push to light pilot light on older Maytag washer. [ 6 Answers ]

I am trying to light the pilot light on my older Maytag dryer. I cannot find any button to push while lighting the light area. All I see are screws, and electrical wire connections. The dryer does not heat and I assume that it is old enough to have a pilot that needs lighting. Thanks

Why would the pilot light go out and where is it located? [ 0 Answers ]

On a rheem furnace, model#3302-77 and serial#089edpn4e,why would the pilot light go out and where is the pilot located?

Does putting gas hot water heater dial on PILOT put pilot light out? [ 5 Answers ]

My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...

Where is pilot located on goodman unit to light [ 3 Answers ]

Turned thermostat on but when you switch to heat cool air comes out and when switched to auto you only hear humming sound and then nothing comes on

Pilot light stays on but pilot switch keeps resetting [ 5 Answers ]

I have a baso L62AA-5 pilot switch and it used to keep resetting. I would hold the switch down for a good minute and the gas lights, but after a half an hour or so it would go back to its reset position. The standing pilot light was always on and never a problem. After a few days of manually...


View more questions Search