Ask Experts Questions for FREE Help !
Ask
    bilborzo's Avatar
    bilborzo Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 19, 2014, 10:15 AM
    What is the 2 contact sensor on my exhaust inducer motor unit housing?
    Changing the fasco draft inducer motor and housing on my furnace. There is a sensor with two contacts pressed into the housing. I am hoping I can pry it free from press fit and re attach on new unit. What is the sensor for?
    bitters's Avatar
    bitters Posts: 348, Reputation: 12
    Full Member
    		  
    #2

    Aug 19, 2014, 10:39 AM
    What is the model number? Your probably looking at the pressure switch. You should be able to remove the screws and take it off.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Water continuing to log in inducer housing [ 0 Answers ]

I have a Lennox high efficiency gas furnace (Model: G26Q3/4). Water is logging in the inducer housing, even after all the pipes, vents, reservoirs were drained. After cleaning, the repairman ran the furnace. For the first 15 min, it works beautifully, then you can start hearing the bearings and...

How do I find a replacement tube that runs from inducer motor to pressure sensor [ 5 Answers ]

The tube has dry rotted I was able to shorten it to make the system work but I can't find a part # for a replacement.

Another name for inducer housing [ 0 Answers ]

Is there another name for the inducer housing?

Bryant 350MAV inducer housing leaking [ 6 Answers ]

I have a 13 year old Bryant 350MAV gas furnace. The 2 halfs of the inducer housing are leaking water. Can these 2 half be pulled apart and resealed? If so what special type of silicone needs to be used if any?

Water in inducer housing [ 5 Answers ]

I have a York Diamond 90 that I am trying to figure out what is causing an issue with it. I seem to have an issue with a lot of condensation building up in the inducer assembly. There are three tubes that feed the condensate trap however it tube from the inducer drain is the one that is draining...

View more questions Search