 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Using older gas control valve
Hi, I have a armstrong sideways funace in my crawlspace the m#G8A1000DC14-18 S#A38261CCA.the polit light wasn't staying on after trying to light it.So I replaced the thermocouple that didn't help.So not having a lot of money I took the gas control valve off my garage furnace and put it on my armstrong after I plumbed it in I got it so the polit light works.now the old valve has a blk wire and a white wite coming out of it.where the newer valve had terminals tr\th so I hooked up the white wire to the white wire and the blk to the blk wire just wraped the wire around terminal ends and the furnace did'nt start I jump the red and white thermastat wire at the 24v transfomer nothing happened.I guess the main electronicmagnetic valve is'nt getting any juice to open it.so maybe the transformer is'nt any good?Any suggestions would be greatly appreciated.Thanks, Greg
|
||||
Check out some similar questions!
Evaporative Emission Control System Purge Control Valve Circuit Shorted what are possible cause codes are p0601 and p0445
Help, I need wiring info for an old ITT general control gas valve on an outdoor swimming pool heater. The valve has 4 terminals, 2 labeled thermostat and 2 for the millivolt generator. I understand the safety devices get wired in series but I am not sure how the on/off switch and thermostat get...
p0443 Evaporative Emission Control System Purge Control Valve circuit Malfunction on mazda melinia s 1996 83k?what is the next stip? I cleared the check engine light and it went off ,and after 60miles driving it cames back again?why and how can I fix it ? Also what is the cheapest way to reset...
I have a new honeywell gas valve for my furnace M# VR8345M 4302. I am trying to use a Johnson Ignition Control G770 MGC-3 to operate This valve. The problem is I want to use the intermittent function of this honeywell valve And the johnson igniter control has no provision for the mv/pv on the...
Please help!! I have a carrier gas pack with a hsp valve/ignitor and after going through the ignition procedure I get nothing. I have replaced the inducer board and the inducer fan does work, however that is the only thing that appears to work. BEFORE spending another 150 bucks on the hsp...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
