Ask Experts Questions for FREE Help !
Ask
    jermwelsh's Avatar
    jermwelsh Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 30, 2014, 07:37 PM
    Troubleshooting a Intertherm Furnace Model mmhb-090abhr-06?
    Came home from a long weekend and found the house cold. One flash, I shut down the furnace and restarted. Everything worked except the fan would not turn on also the furnace did not shut down and give me the same code. So I just turned the furnace off. The fan will work when I place the switch on fan. I am guessing it is the fan switch.
    Grady White's Avatar
    Grady White Posts: 1,417, Reputation: 59
    Ultra Member
    		  
    #2

    Apr 1, 2014, 07:31 PM
    If the fan is controlled off a circuit board, the relay for the fan in the heating speed is probably shot. You can test by measuring voltage from the fan 'heat' terminal to neutral. After a few seconds of the burner firing (no longer that probably 30 seconds) you should get 120 volts AC from that terminal. If you do, the problem is not the board.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Troubleshooting Intertherm Model EB2-012HB [ 2 Answers ]

I recently purchased a 2004 mobile home It has been sitting unoccupied for the last four years. The heat blows but moderately; when extreme cold conditions it does not adequately heat the home, even with thermostat setting on maximum. I have examined the unit, the filters were in good condition. I...

Miller furnace mmhb 090abhr 06 [ 0 Answers ]

Where can I find a service manual for this model or does anyone know where the flame sensor is located?

Troubleshooting a Intertherm Furnace Model mmhb-090abhr-06? [ 1 Answers ]

HI, When I turn it on , I get two flashes on red light. Will not start up. Thank you.

Need help with a intertherm gas furnace mmhb-070abhr-06 [ 0 Answers ]

Red light on the black box flashes 2 times and it says that it is not receiving signal from the central fusical switch not opening up in time

Intertherm mmhb 056 electric ignition furnace [ 5 Answers ]

Getting flashing light two times-indicates that control ion lockout due to signal not received by control that inducer pressure switch not closed n time, please help! p.s recently replaced ignightor and thermostat

View more questions Search