Ask Experts Questions for FREE Help !
Ask
    sydthekid's Avatar
    sydthekid Posts: 2, Reputation: 1
    New Member
     
    #1

    Dec 25, 2012, 08:21 AM
    Troubleshoot 50a50-471
    The system thermostat is calling for heat and nothing is happening at the furnace. The White Rodgers 50a50-471 control light is flashing 3-times and the code says pressure failure. I jump the switch out and the flashing light goes blank.
    mygirlsdad77's Avatar
    mygirlsdad77 Posts: 5,713, Reputation: 339
    Plumbing Expert
     
    #2

    Dec 25, 2012, 05:19 PM
    When you kill power to the furnace, wait a few seconds and reapply power, does the draft inducer motor run (with the stat calling for heat)?
    sydthekid's Avatar
    sydthekid Posts: 2, Reputation: 1
    New Member
     
    #3

    Dec 26, 2012, 05:02 AM
    No, I pulled the inducer fan motor plug and when the board cycles before the blinking light going out all together no power ever appears. I have the air pressure switch jumped out so I think the motor shouldn't be an issue. I'm trying to find out why the flashing light goes blank, as in no light at all after it cycles.

    Thank you for your interest in this problem.
    Syd

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

White rogers 50A50-471 and -473 [ 5 Answers ]

My furnace flame goes out at times. Sometimes it won't light, other times it lights and quits after a few seconds or almost a minute. Then it might run for many minutes. One time I got a steady LED indicator light, controller needs replacement. Then it works again. I have the White Rogers...

White rogers 50A50-471 [ 0 Answers ]

I can't reply through the web page it just redirects me to register and says my username is already being used... so I re applied with a new user name My Original Question: My furnace flame goes out at times. Sometimes it won't light, other times it lights and quits after a few seconds or...

Help with a White-Rodgers Model 50A50-471 Furnace Control Board [ 0 Answers ]

My Problem: My furnace is pumping out tepid cool air Last night my house started blowing tepid cold air. I turned the heat down until it "clicked" off from the thermostat in the main room. I went down into my basement and opened up my furnace. I had not changed the filter in the last 3 years...

White roger 50a50-471 [ 2 Answers ]

I need a new 50A50-471 controller. Is it available in Canada? Thanks, Javid

Burned White-Rodgers 50A50-471 Furnace Control Board [ 29 Answers ]

I woke up this morning full of Christmas cheer and then I noticed it was too cold (I have compromised with my wife to turn the heat down to 65 degrees at night, but not 60! Brrr!) I noticed the circuit breaker was tripped so I reset that. The circulation blower comes on but no ignition or...


View more questions Search