Ask Experts Questions for FREE Help !
Ask
    Terrycloth's Avatar
    Terrycloth Posts: 16, Reputation: 1
    New Member
     
    #1

    Sep 3, 2012, 10:45 AM
    Trouble shooting an R22 system
    Another question when you turn the thermostat to call for cooling nothing comes on but when you switch it to fan the indoor fan comes on. I then jumped everything out at the thermostat and everything comes on. The pressures on the system were 30 degree coil temp and 160 on the high side which is low for sure. Could this be a faulty thermostat as well as being low on refrigerant ?
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
     
    #2

    Sep 4, 2012, 10:03 AM
    Possible

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trouble shooting my york stellar system [ 0 Answers ]

I have a York Stellar heat pump and A/C recently we turned the A/C on. It seemed to work for a while than stopped cooling. I cleaned dirt and debris from out side unit (inside and out) Chane filter religiously... Ice accumulates on copper/brass fittings where lines leave and return outside unit?...

Sony compact AV system trouble shooting? [ 1 Answers ]

I have a Sony compact AV System DAV-FC9. My husband was watching a DVD when the power went out cause of a storm. Now the unit won't come out of the standby mode. You press the power button and it flashes and the disk # 4 flashes on the tray that the DVD is in. It came on once for a second, but went...

Do I have to replace the whole r22 system if I upsize from a 2 to a 2.5 ton r22 unit [ 6 Answers ]

My r22 heat pump unit is undersized for my house. It is a 2 ton and the builder should have installed a 2.5 ton. Do I have to replace the whole system, inside and out, if I upsize to a 2.5 ton or can I change out just the part that is the wrong size to cool the house? I can't really afford the cost...

How much more expenseve is a 410 system vs an r22 system [ 2 Answers ]

How much more expensive is a 410-a system vs an r-22 system

Trouble shooting a 3phase system [ 10 Answers ]

Hi All, I have a 480 VAC 3 phase ungrounded system. We monitor the system via a set of lights for each phase. If one phase goes to ground then that light should glow bright. In my case I have the B phase light out completely. While trouble shooting the problem I found which disconnect switch was...


View more questions Search