My code states that I have a faulty limit swicth?? How do I test limit switch?? Can I reset the fault?? :confused:
Check out some similar questions!
Trane XL20i heat pump requires Trane 900 series thermostat? [ 2 Answers ]
Hi, I was wondering if the Trane XL20i heat pump requires the use of Trane's 900 series thermostat or if a Honeywell VisionPro IAQ thermostat can be used.
TRANE vs Amana in New Home: Is a TRANE upgrade worth $4k? [ 8 Answers ]
Background/Details: Building new home in North Texas. Closing at end of August. Builder and I are in dispute over what hardware to install for the AC. House is gas heated so this is about the AC side only. The AC hardware that comes with the house is made by Amana (under license to Goodman...
What does it mean when York emergency heat light flashing 5 times? [ 1 Answers ]
HI, what does 5 flashes mean? Just got cold enough outside (for me) to turn the heat on for this fall. Heat comes on and off like usual but noticed the flashes. Have turned system off waited 15 minues then back on. Starts up fine but after awhile, 5 flashes start again. Any help is greatly...
Heat won't come on in auto mode error from diagnostic panel flashing 3 times [ 2 Answers ]
In January 2006 I had a new furnace installed ( a coleman gas furnace Model # BGAA070BDTBJ) and this ran fine throughout the rest of that winter. Early in the summer our thermostat went out and I installed a new Hunter thermostat # 42999 and I hooked it up as shown in the directions and it worked...
View more questions Search
Add your answer here.