Ask Experts Questions for FREE Help !
Ask
    crr99999's Avatar
    crr99999 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 9, 2010, 07:50 AM
    TRANE XE80. Problem Code: 1 long and 4 short blinking lights
    One morning about a month ago, my furnace wouldn't start. The repairman came and replaced the "inducer draft motor and blower assembly". Not cheap! At that time I didn't know enough to record the blinking light code, but looking back I think it was blinking 3 times.

    Now, a month later, at 6 am when the heat should come on to warm the house to 65 degrees, the furnace has to make several attempts over a 10 minute period before it lights and blows heat. The fan starts up but the burners do not light so the fan turns off. During this time, the indicator light flashes 1 long and 4 short blinks. Eventually the burners light and the furnace runs till it heats the house. There are no problems once it gets running. There are no problems during the day. In the evening the furnace kicks on as it should and there are no problems. The next morning, I have the same lighting problems.

Check out some similar questions!

Trane xe80 4 flash error code [ 1 Answers ]

My 8 year old Trane XE80 heat comes on then when it cycles off the fan keeps running and I get 4 flash error code. Help please. Thanks

Trane XE80 furnace occasionally produces no heat, error code 4 [ 3 Answers ]

Hello, I have a Trane XE80, model number TDD080C936E0. A few weeks ago, it started blowing only cold air with error code 4 - high temperature limit open. If I shut it down, and start it up again in about an hour or so, sometimes it comes back on, sometimes it doesn't (produce cold air only). ...

Trane xe80 code 4, no heat [ 5 Answers ]

All summer the cooling worked fine, when I switch over to heat this week, it didn't come on. The control box shows a code 4, which says "THERMAL PROTECTION DEVICE OPEN" Any help?

Trane XE80 blows cold error code 22 [ 5 Answers ]

From my earlier post ignite for a few seconds the stops, now, heat commanded, blower motor runs, no ignition, and flashes code 22 Help!

Trane XE80 [ 1 Answers ]

My 10 year old Trane XE80 in my woodworking shop lately cannot put out enough heat to satisfy the thermostat, which yesterday was set at 72 degrees on a 37 degree day. The steel building is completely insulated, and this has never happened before at this outside temperature. The furnace seems to...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.