Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Blower motor of Trane XE80 furnace won't start
[ 8 Answers ]
I have a Trane XE80 gas furnace. The purge motor and burner go on, but main motor won't run. LED flashing light flashes continuously when burner is on however, when the burner shuts off, the LED light flashes 4 times at an interval. I tried to look for a reset button on the main blower motor but...
York Blowing Cold Air - Flash 7
[ 3 Answers ]
York Diamond
Trane XE80 furnace occasionally produces no heat, error code 4
[ 3 Answers ]
Hello, I have a Trane XE80, model number TDD080C936E0. A few weeks ago, it started blowing only cold air with error code 4 - high temperature limit open. If I shut it down, and start it up again in about an hour or so, sometimes it comes back on, sometimes it doesn't (produce cold air only). ...
XE80 Trane Furnace-no ignition of gas
[ 1 Answers ]
I have furnace that calls for heat from thermostat, ignition coil(stick) lights up, sometimes I get gas ignition and sometimes not, then the gas shuts down. The blower motor continues to run. I cleaned the temperature sensing rod. The control board lights up with the message "Internal control...
Trane XE80
[ 1 Answers ]
My 10 year old Trane XE80 in my woodworking shop lately cannot put out enough heat to satisfy the thermostat, which yesterday was set at 72 degrees on a 37 degree day. The steel building is completely insulated, and this has never happened before at this outside temperature. The furnace seems to... View more questions Search
|