Ask Experts Questions for FREE Help !
Ask
    richogtx's Avatar
    richogtx Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 28, 2011, 07:23 PM
    Trane xe80 gas furnace led blinks continuosly what's the problem?
    Noticed that furnace blower was running continuously and no heat. Looked at thermostat and Gas Flame symbol {call for heat} was not on. Turned heat off. Inspected furnace and noticed continuously blinking LED on control module. Turned off power to furnace. Waited a few minutes then turned power back on and reset thermostat and set temperature. Observed furnace and normal sequence of Vent fan, igniter and ignition of burners and main blower operating sequence. Unit has been on for 24 hrs and has not repeated the blowing fan cold air situation again. The LED is still continuously blinking so what type of problem do I have?

Check out some similar questions!

TRANE XE80. Problem Code: 1 long and 4 short blinking lights [ 0 Answers ]

One morning about a month ago, my furnace wouldn't start. The repairman came and replaced the "inducer draft motor and blower assembly". Not cheap! At that time I didn't know enough to record the blinking light code, but looking back I think it was blinking 3 times. Now, a month later, at 6 am...

Trane XB LED blinks 5 times and blower won't stop running, but no heat. [ 8 Answers ]

Problem: Trane XB LED blinks 5 times and blower won't stop running, but no heat. Any ideas what the solution is? I am thinking some kind of fan control board. I can shut off power to the whole unit, but when I power back on I get the same problem. Blower runs with no heat. The thermostat can be...

Trane furnace XB90 diagnostic LED light is flashing 4 times [ 1 Answers ]

My furnace does not blow out any heat but only cold air blows out.. trane XB90 and the diagnostic LED light is flashing 4 times... please help we are cold.. the code for 4 times flahinf light says open limit device.

XE80 Trane Furnace-no ignition of gas [ 1 Answers ]

I have furnace that calls for heat from thermostat, ignition coil(stick) lights up, sometimes I get gas ignition and sometimes not, then the gas shuts down. The blower motor continues to run. I cleaned the temperature sensing rod. The control board lights up with the message "Internal control...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.