Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Blower motor of Trane XE80 furnace won't start
[ 8 Answers ]
I have a Trane XE80 gas furnace. The purge motor and burner go on, but main motor won't run. LED flashing light flashes continuously when burner is on however, when the burner shuts off, the LED light flashes 4 times at an interval. I tried to look for a reset button on the main blower motor but...
Trane xe80 code 4, no heat
[ 5 Answers ]
All summer the cooling worked fine, when I switch over to heat this week, it didn't come on. The control box shows a code 4, which says "THERMAL PROTECTION DEVICE OPEN" Any help?
XE80 Trane Furnace-no ignition of gas
[ 1 Answers ]
I have furnace that calls for heat from thermostat, ignition coil(stick) lights up, sometimes I get gas ignition and sometimes not, then the gas shuts down. The blower motor continues to run. I cleaned the temperature sensing rod. The control board lights up with the message "Internal control...
Trane XE80 blows cold error code 22
[ 5 Answers ]
From my earlier post ignite for a few seconds the stops, now, heat commanded, blower motor runs, no ignition, and flashes code 22 Help! View more questions Search
|