Ask Experts Questions for FREE Help !
Ask
    Susan carpenter's Avatar
    Susan carpenter Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Sep 27, 2014, 02:12 PM
    Thermostat has no display. Is the problem in the thermostat or the furnace ?
    No display in thermostat. Checked breakers for furnace and AC. Reset furnace/AC unit. What next?r
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Sep 27, 2014, 05:29 PM
    Could be a number of things. Does your thermostat have a battery? It could be a bad battery. It could be a bad control board, it could be a bad low voltage transformer, it could be the fuse on the control board. The board is inside the air handler section of the heater. If you remove the front of the heater, you should see a small red or green diode light. It may be a steady light or a slow flash, depends on your model. If there is no light, look for the fuse, like one in your car, on the board and replace it, typically 5 AMP.
    donsor's Avatar
    donsor Posts: 8, Reputation: 1
    New Member
    		  
    #3

    Sep 27, 2014, 07:01 PM
    As ms0641 said, check if you have power in your thermostat. If your system is anything like mine your stat gets it power from a 110V circuit via Xformer separate from the 208V system powering your AC. Your AC is protected by a ckt. Breaker and a fused disconnect. Check that you power at the disconnect. But your problem may just the stat which is inexpensive to replace.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Thermostat or furnace problem? [ 6 Answers ]

New condo only a few years old. Thermostat set at 70 degrees. Go to bed and wake up its 65 degrees in the condo and thermostat is set to 70. Freezing my buns off here. HELP!!

When I switch the thermostat to heat, the display goes blank and furnace doesn't work [ 1 Answers ]

Have a Honeywell simple digital non-programmable thermostat. The AC is fine. When I switch from AC to "off" or "heat" position, the display goes blank. The heat does not come on, but the blower will if I switch it from "auto" to "on" obviously blowing cold air. This is an all in one (gas heat...

Goodman furnace guso50-2 thermostat wiring instructions for 2 wire thermostat [ 2 Answers ]

Looking to hook up a 2 wire heat only thermostat as the door with the weiring diagram is missing it's a goodman guso50-2?

Thermostat or the Furnace Problem [ 0 Answers ]

I have Lenox system with Honeywell Programmable thermostat. My Ac and furnace work fine. Only problem with furnace is if I feel cold in the house and if I raise temperature few degrees on the thermostat, I can hear my furnace starting. After about 5 seconds, it will turn off. After about 3-4...

View more questions Search