Ask Experts Questions for FREE Help !
Ask
    scbmkk1951's Avatar
    scbmkk1951 Posts: 1, Reputation: 1
    New Member
     
    #1

    Aug 8, 2013, 11:42 AM
    Tempstar model ca5536uka1
    My A/C unit started making noise at the exhaust fan. The fan motor sounds like the bearing is going bad. Is the fan motor connected to the compressor in any way or can I just replace the fan motor
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
     
    #2

    Aug 8, 2013, 05:27 PM
    The fan is not connected to the compressor, just make sure you get the right rpm when changing it.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Tempstar Model END4X24C14A2 [ 1 Answers ]

When I turn the thermostat up the furnace turns on and it ignites for about 30 seconds and then turns off. I get 4 flashing lights and if I turn the switch off and then back on it runs again for about 30 seconds and once again turns off and flashes the 4 green lights. If I leave it alone it will...

Tempstar model ntc6075fba1 [ 0 Answers ]

I have a tempstar model furnace NTC6075FBA1. My consultant explained that I need to replace the reduce draft motor. When we turn on the heat switch, nothing happens and the fan is stuck. What am I looking at as far as price for replacing this motor?

How many tons is the tempstar model # TCA224AKA4? [ 3 Answers ]

Model # TCA224AKA4 Serial # L015082695 25 amp breaker 208/230 volt phase 1

I have a 1994 Tempstar 5000 CA5536UKA1 [ 0 Answers ]

The relay has a black button it I push it will turn the fan. But, now the black reset will not stay in. When I push it in it works. Do I just need a new relay or whatever that unit is?

Tempstar model #PGF048K080A / No heat. [ 0 Answers ]

I have a Tempstar model# PGF048K080A tried to turn on the heater and no heat. So I inspected the unit & found the pressure switch was burned out. Replaced the pressure switch & still no heat. Now I believe the draft inducer motor is also burned out. I put my ohms meter on the inducer motor and get...


View more questions Search