Ask Experts Questions for FREE Help !
Ask
    lz4004's Avatar
    lz4004 Posts: 1, Reputation: 1
    New Member
     
    #1

    Sep 7, 2009, 05:30 AM
    Taco zone valves
    Will a taco zone valve head 555-050rp work with 555-102 unit?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Sep 7, 2009, 05:45 AM
    http://www.taco-hvac.com/uploads/Fil...ry/102-076.pdf


    The Taco 555-050RP is the replacement part number I believe so you should be OK BUT see the above pdf and at the bottom is Taco's phone number. Give them a call just to be sure.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Are zone valves or zone thermostats possible with a steam boiler? [ 1 Answers ]

I have an old 4 story building with one thermostat controlling the steam heat to all floors. There is a commercial space on the ground floor and they are complaining that they don't get enough heat sometimes (and on occasion get too much!) They have suggested that there is some way to place a...

Wiring old taco zone valves 555-102 to furnace [ 1 Answers ]

Help! I have a two zone system of water base boards hooked up to an oil furnace (or is it a boiler?). I had it serviced a month ago and I just realized that the wiring on the two zones, which are controlled by taco 555-102 zone valves, was reversed so that the wrong thermostat controlled the wrong...

Wire zone valves [ 3 Answers ]

I have a oil fired boiler with taco 562 zone valves.My wires are from transformer red&green.Wire from thermostat are red& green.On my zone valves the wires are red,green&yellow.Aperson who said he could fix zone valves had taken all wires off the zone valves.The zone valves have numbers 1,2,3,which...

Zone valves [ 2 Answers ]

Looking for a wiring diagram for a new dunkirk boiler . Just the diagram for the 3 zone valves. Company says that the boiler transformer is enough to run three zones ( 24v) . Or do I need to add transformer. Just can't figure out the wiring from one zone valve to another. Contacts on each zone are...


View more questions Search