Ask Experts Questions for FREE Help !
Ask
    Mike1379's Avatar
    Mike1379 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 13, 2008, 06:24 AM
    T-stat or Circuit board?
    Hello, I have an Air Pro model #BGM10016B forced air heater with a Honeywell digital t-stat. Yesterday the heat kicked on like normal but wouldn't shut off after reaching the proper temp. I set the t-stat to off but the heater still wouldn't shut off. The heater has a circuit board with an LED but no codes were being displayed. I removed the t-stat from the wall and turned the heater off and it shut down. I turned the heater back on and installed the t-stat and once again the heater kicked on even though the temp was above the desired setting. I changed the battery in the t-stat and all seemed well until this morning when once again the unit would not shut off until I removed the t-stat. Is the problem the t-stat or is the circuit board not obeying the commands? HELP!
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Oct 13, 2008, 11:59 AM
    If you remove the thermostat only and the furnace goes off it might be the thermostat or a short in the low voltage wiring to the thermostat from the furnace.

    Remove thermostat then turn power on to furnace. If the furnace runs it probably has a short in the low volt wiring.

    Second test is to hook thermostat back up. Then if the furnace runs past the set point of the thermostat it is possible the thermostat.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Circuit Board [ 3 Answers ]

I had the HVAC guy out and he said that the circuit board was bad. He then spent half the morning looking for a new board, but said he could not get one anywhere. I have a hard time believing that this is the case and wanted to get a little help. The number on the circuit board is CES0110057-00...

AC circuit board bad or not [ 1 Answers ]

I have a circuit board out of my evaporator unit it is a carrier system the board is burnt horribly at the ac input part of the board everything else seems OK wondering if a surge or something got it before I go and buy a $200 board and watch it fry in my face thank for any help

Where can I get a circuit board? [ 2 Answers ]

I need a circuit board for a bryant furnace Were can I get a circuit board for a bryant model 395cav036111

Circuit board [ 15 Answers ]

Hello all. New at this site and loving it. Thanks for having me. My question is this. I'm having trouble with a disco light. This guy came in and dropped it. He says there might be wrong with the ic chip or it could be fuses. OK first things first I replaced all the fuses with new ones....

Circuit board [ 5 Answers ]

Good afternoon, I have a weathermaker 8000 carrier and recentlly had to change out 24 volt transformer by the circuit board, it runs for 20 minutes or so then pops the 3amp fuse on circuit board, I also changed to 5amp fuse still the same could it be thermostat problem?

View more questions Search