Honeywell magicstat?

RecruiterBrad Posts: 1, Reputation: 1

New Member

Aug 10, 2011, 11:30 AM

Honeywell magicstat?

How do I change the display from fahrenheit to Celsius?

Stratmando Posts: 11,188, Reputation: 508

Uber Member

Aug 10, 2011, 11:55 AM

Adjust screw "C" out 1 turn for celsius:
http://customer.honeywell.com/techli...0s/69-0653.pdf
Page 6

Add your answer here.

Check out some similar questions!

Honeywell MagicStat 32 - Model CT3200 [ 9 Answers ]

Hi, I have a Honeywell Thermostat MagicStat/32 which is saying (not Flashing) "bat low." As per the instruction manual, I changed the Batteries. This did not clear the screen. I tried another set of new Batteries, which again did not clear the screen. I am sure I put them In correctly. ...

Honeywell magicstat 28 troubleshooting? [ 3 Answers ]

My thermostat's fan will not turn off. Do you have any suggestions?

Is the Honeywell MagicStat/32 thermostat a two stage? [ 0 Answers ]

I have 2 stage central air unit plus the gas forced air furnace. I'm not sure this MagicStat/32 will control the two stages of air conditioning.

Honeywell magicstat manual [ 1 Answers ]

My Honeywell MagicStat thermostat indicates 'system on', but my furnace is not on and the current temperature in my house is 10 cooler than what I have programmed it to be (during the heating season). I have found turning the thermostat to 'off' and then back to 'auto' gets the furnace to start,...

Honeywell MagicStat/32 or Furnace Failure? [ 4 Answers ]

I've changed the batteries on the thermostat when the "lo bat" message displayed. Per the user manual, I had to install the batteries backwards for 10 seconds in order to reset the unit. I then reinstalled the batteries in the proper manner and began to program the unit. Approximately 20 seconds...