Ask Experts Questions for FREE Help !
Ask
    grickol's Avatar
    grickol Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jun 14, 2011, 10:17 PM
    Installed new cnt03797.blower won't cut off
    Do I have wiring crossed
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Jun 15, 2011, 07:30 AM
    Its hard to say,not being there, what did you hook them to?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

My blower on inside unit will not cut off I cut and crimped wires back together [ 1 Answers ]

Where do I put the blue and red wire to the blower on the inside unit

E2EB-012HA the blower motor will not cut off [ 1 Answers ]

I changed out the transformer and now I can't get my blower to turn off E2EB-012Ha

New Blower installed; now unit outside doesn't kick on.what next? [ 0 Answers ]

My Blower was making a terrible noise, then I smelled a burning, so replaced the blower. Outside unit was fine, now that I have a new blower the outside unit won't come on. It's a amana copeland, I just can't figure this out. Suggestions?

Blower won't cut off [ 5 Answers ]

I have an Amana central unit made in 1996. I have no 24v out of the control board to the thermostat. The return Air blower runs all the time and I can only stop it by pulling The main fuses. I replaced the control board but it Still does the same thing. Any help would be greatly Appreciated. ...

Installed a new blower in furnace [ 5 Answers ]

I have installed a new blower motor and the motor blows to fast and cuts off three to four times a cycle. Any help?

View more questions Search