Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Low pressure cut-off switch problem
[ 4 Answers ]
My well occasionally runs dry, so I recently replaced my pressure switch with a Square D switch with the low pressure cut-off to protect the pump. It is set for a 40-60 psi range (same as the old one). Now about half the time, when when it reaches the 40 psi cut-in, the pressure suddenly drops...
Cut in pressure?
[ 2 Answers ]
I'm about to attempt re-plumbing a well-x-trol wx202 pressure tank as the pipes are starting to leak slightly. The tank says its pressure should be the same as the cut in pressure. Am I right in assuming that's the point the pump turns on? Any tips or pitfalls you can give are appreciated. Thanks
Cut off switch for drip pan
[ 1 Answers ]
Where would a cut off switch for secondary drip pan be located?
Pressure tank cut off switch defective?
[ 3 Answers ]
When I run too much water in the house the cutoff switch shuts down till I manually flip the lever to get it back running again... we cannot run more than 2 faucets at a time.. any ideas?the switch is roughly 2 months old... turns on around 30 shuts off around 50.. thanks View more questions Search
|