Ask Experts Questions for FREE Help !
Ask
    animal447's Avatar
    animal447 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 15, 2010, 09:00 PM
    New installed furnace won't run
    I just installed a comfort aire 80% 120,000 BTU furnace. When I started the furnace inducer fan started the electronic ignitor started 10 seconds later and successfully lit the burners on the first try. They burn solid blue but go out within 10 seconds of the ignitor going off. The indicator light never turns from a solid green so no diagnostics from there. The furnace cycles three times without success. Brand new so I don't think it could be the flame sensor. Any help would be greatly appreciated.
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #2

    Feb 15, 2010, 09:06 PM

    Flame sensor wiring, flame sensor position, flame detect circuitry faulty, switch the wires on the 24 V secondary (polarity error), Measure the flame sensor current in uA or a bad ground.

    I'd start by switching the secondary.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

6yr old goodman furnace won't run.. had ignitor replaced in 04, could it be out again [ 1 Answers ]

6yr old goodman gmt090 running this morning at 830, left house came back 230, house cold reading 57 degrees. Had ignitor replaced in feb of 04, could it be out again..

My jeep turns over but won't start. It will run when I put starting fluid but won't run [ 2 Answers ]

My Jeep will will turn over but won't start. I changed the "O" ring in the injectors cause I heard that might be a problem, still nothing. It will start when I spray starting fluid but will only run until it burns through the fluid.

I have romex installed in a conduit for about an 8ft run. Is this OK? [ 2 Answers ]

I upgraded my garage to add a couple of receptacles. The bulk of the wire is running through the rafters of my basement, but I enclosed about the last 8-10ft of romex NM-2 in 1" PVC conduit for mainly protection since this was going to be exposed. Now I have some concerns after reading that I...

Installed new thermostat, now a/c outside unit will not run [ 31 Answers ]

We installed a Honeywell RTH6400 thermostat in January. We now need a/c & outside unit will not come on, inside unit runs. When we installed this we thought everything was hooked up right, but who knows. We've pulled the cover off the thermostat & we have a blue wire that is taped, should it be...

View more questions Search