Ask Experts Questions for FREE Help !
Ask
    samuelmaylor's Avatar
    samuelmaylor Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 20, 2009, 07:38 PM
    Adding a zone
    I would like to add a zone to a oil-fired forced hot air system
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Nov 20, 2009, 08:00 PM
    That would be nice, do you have any questions?
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #3

    Nov 20, 2009, 08:07 PM

    I'll let you much on this URL for awhile: EWC Controls

    Zoning should contain a bypass damper. It connect supply and return air.

    If it's just one room that gets too hot or too cold, You can just motorize that one damper without a zoning control.

    After you munch, you can come back with questions.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Adding a zone to oil fired hot air furnace [ 0 Answers ]

I would like to add a zone a oil fired forceh hot air

Adding a second zone [ 3 Answers ]

How do I add a second zone to a trane xr 90 hot air gas furnace. The duct work is set up for 2 zones and the thermostat are already installed. I just need to know what to add to the furnace and how Thanks

Adding a zone for heat in the basement-Is permit required? [ 4 Answers ]

Hi, We are finishing our basement. I want to add a zone for heat in the basement. Is permit required to put heat in the basement. Our house is heated with oil. I applied for permit for finishing the basement as a home owner and got the permit! I live in Massachusetts! Thank You for answering my...

Adding a second zone to Rheem fhw heat [ 1 Answers ]

I have an 10 year old Rheem forced hot water heater I am going to add a second zone with taco zone valves I am familier with hooking up the zone vavles but how about the heating system It just has one thermastat hooked up now do I have to add a low voltage to the circuit or can it be run off the...

Adding a Zone to my hot water furnace [ 1 Answers ]

I am going from a single zone hot water system to a dual zone. Have Aqua-stat #L8148E and two thermostats with two Honeywell #V8043F 1036 zone vales already mounted & ready to go but need help with the electrical wiring. Can anyone help me with a simple schematic that will get the job done or some...

View more questions Search