Ask Experts Questions for FREE Help !
Ask
    frisbied's Avatar
    frisbied Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Oct 19, 2008, 03:19 PM
    In wall 220 heater
    1 pole breaker with 2 slots for wires to heater (red and black wire) aiw 12 wire. At heater red to red and black to black, bare ground to green screw. Test light to both leads and nutral lite. Why not working.
    smearcase's Avatar
    smearcase Posts: 2,392, Reputation: 316
    Ultra Member
    		  
    #2

    Oct 19, 2008, 04:01 PM

    If you are using a tandem breaker (one breaker that has two switches and fits in the space of one standard breaker) you are only getting 110 volts, not 220. You need a two pole breaker, if the breaker is a tandem as described above.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Gas wall heater will not light [ 3 Answers ]

Hi, I have a William Monterey Gas top vent wall heater. I cannot get the pilot to light. I replaced the thermocouple and this did not fix the problem. The gas is coming through as I can both hear it and when I hold the pilot button down it will stay lit (till I take my finger off even after...

240volt wall heater [ 9 Answers ]

Can it be wired to plug into a dryer hookup and if so how:cool: :cool:

Wall heater pilot light lit, but cuts off when I turn heater on [ 6 Answers ]

I have a wall heater, the pilot light was out so I re-lit it a couple days ago and it went on.. about 4 hours later I noticed it was out again... same thing off and on for three days... this time I lit the pilot and turned the heater on it immeditly made a click sond and went out completely... it...

Old wall heater [ 2 Answers ]

Wall unit will not shut off. Already tested thermostat. Can I replace valve or some how fix? Thanks kennywb

View more questions Search