Check out some similar questions!
TRANE XE80. Problem Code: 1 long and 4 short blinking lights
[ 0 Answers ]
One morning about a month ago, my furnace wouldn't start. The repairman came and replaced the "inducer draft motor and blower assembly". Not cheap! At that time I didn't know enough to record the blinking light code, but looking back I think it was blinking 3 times. Now, a month later, at 6 am...
Trane XB LED blinks 5 times and blower won't stop running, but no heat.
[ 8 Answers ]
Problem: Trane XB LED blinks 5 times and blower won't stop running, but no heat. Any ideas what the solution is? I am thinking some kind of fan control board. I can shut off power to the whole unit, but when I power back on I get the same problem. Blower runs with no heat. The thermostat can be...
Trane furnace XB90 diagnostic LED light is flashing 4 times
[ 1 Answers ]
My furnace does not blow out any heat but only cold air blows out.. trane XB90 and the diagnostic LED light is flashing 4 times... please help we are cold.. the code for 4 times flahinf light says open limit device.
XE80 Trane Furnace-no ignition of gas
[ 1 Answers ]
I have furnace that calls for heat from thermostat, ignition coil(stick) lights up, sometimes I get gas ignition and sometimes not, then the gas shuts down. The blower motor continues to run. I cleaned the temperature sensing rod. The control board lights up with the message "Internal control... View more questions Search
Add your answer here.
|