Ask Experts Questions for FREE Help !
Ask
    trentman1's Avatar
    trentman1 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 12, 2010, 08:47 PM
    Plus 90 bryant
    I think my blower motor is going and I can't find any numbers or info on it to get another. Anyone have any ideas?
    wmproop's Avatar
    wmproop Posts: 3,749, Reputation: 91
    Ultra Member
    		  
    #2

    Feb 12, 2010, 08:55 PM
    Are you looking on the motor it should be there, the hp motor speed,the direction it runs,all is very important
    KC13's Avatar
    KC13 Posts: 2,556, Reputation: 99
    Ultra Member
    		  
    #3

    Feb 13, 2010, 09:45 AM

    The motor rating label may be concealed by the mounting band. The furnace label may provide info about the blower motor. What is the complete model #?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Bryant plus 90 [ 0 Answers ]

Code 31 . The ignitor is taken out for replacement. The inducer moder does not start in the beginning. It starts after the 90 second blower motor runtime. What might have gone bad?

Bryant [ 1 Answers ]

I have a bryant plus 80 series g furnace. Model 395CAV048111. My furnace will start a cycle but goes off. Then the led will flash 5 times, pause and then repeat the 5 flashes. Also, if I unplug the furnace it will reset and complete a cycyle, then it will start going off again. Any help would...

Bryant 310aav0360 [ 2 Answers ]

I think my communication bord is out in my furnace.(Bryant 310AAV0360) How much do they run? My heat would come on for no more than a minute and then it would shut off.

Bryant code 33 [ 1 Answers ]

Bryant gas funace model 310aav042090aaja. Code 33. Wired around limit and it worked fine. Replaced with new limit throws code again. Vents clear. Filter clear. What next? Is it really getting too hot? Runs about 4 minutes before throwing code and cycles down about 3 minutes.

Bryant Burner [ 3 Answers ]

I have a valve on a Bryant Burner for an old gas furnace. There seems to be a problem with the gas valve that feeds the burner. Are 40 year old valves available? Thank you. Dennis

View more questions Search