 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Short cycling furnace
Hello Again,
Thank you for the previous help suggestions. The last suggestion I received mentioned the possibility of a defective limit switch. I replaced the switch but that did not solve the problem. However, I did received a fault LED, "defect or flaw in gas flow". I checked my line, checked the tank, and my connections, did not find any leaks, when I turned on the unit again, hoping to receive the same fault, I could not get the LED to display again. At this point I'm not sure what to try next. I am close to the house however and will be for a few days so if someone has another suggestion, which would be appreciated, I can try it sooner than the last post. I would be able to respond in a more timely manner. Thank you for all your help and suggestions. Michael1 |
||||
Check out some similar questions!
The induction motor comes on then the heat it's stay's on for two mines then cut off it short cycling all nights. Is this a bad pressue switch ,or abad board
I have a Bryant 80 furnace , had the ignitor replaced in November. Since then the furnace will power up, ignitor and burners will go and then when the blower turns on the burners go out, the blower will go for about 90 seconds and then shut down. It will do this repeatedly sometimes as many as 30...
I have an older Sears "Fifteen" horizontal gas furnace (#867767840) located in the crawl space. Recently it has been short cycling, meaning it starts a normal cycle, runs for approximately 1 minute, stops for several minutes, then starts another 1 minute cycle. This repeats until the set...
I have a Trane XL80 (Model #TUD060A936A0) that has been converted to a White-Rodgers (Model #50E47-060). When the thermostat calls for heat, the furnace short cycles until it is manually shut off. There is no indicator light on this unit to tell me what the problem may be. What else could...
My 1983 heil model NUGK075DG01, natural gas, forced air furnace is running but only heats the house to 67 degrees no matter how high I set the temp, the fan continuously runs (in auto on thermostat) and the burner will cycle for 3-4 min. then shut-off for 10 min.. I have powered down and back-on,...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
