Search:
Type: Posts; User: jake4
Search:
Search took 0.01 seconds.
-
I have seen on two units this winter, same model, where your pressure switch hose connects to draft inducer housing, restricted. Pull hose off and run paper clip in port a couple of times, and...
-
You didn't get this from me 1-800-756-2926 maytag tech line use this acct, tell them you can't find your acct #
-
Might need water valve, check screens in hoses first and in the valve , where the hoses screw on
-
Stuck electronic damper, probably will need to call for service, something you do not want to guess at , could get expensive
-
You have sealed burners I would assume, don't lift top, take screws out of burners, then lift top. You will need to replace the gas lines you broke, sometimes comes in assembly, just not a line
-
Is this a matching pair to a front load washer
-
Pop the top from the front use putting knife to press in catches , hinge top up, remove to screws in front panel, slide panel downward.
-
Thermistor failure, little round black device on the back of dryer, you need to remove the panel to get to it.
-
Does this dryer have a touchpad test , this will light up all buttons on touch pad.
-
If this is the stove I am thinking about , couple years old, their was several service bulletins on the burner design and spark module board and also need electrical noise filters
-
Your switching from 4 to 3
-
Take the bottom panel off, three screws usually metric or torx, and the tech sheet is on the left in envelope, that might help
-
Check your amp ratings verus the wire size and breaker
-
You will need a defrost drain heater, take a piece of bare solid copper wire, 14 gauge works great, wrap it around the defrost heater and then insert in the drain about two inches, let me know if...
-
If this is an electric dryer it will probably need a new thermal fuse , located the on the back of the dryer neat the exhaust vent, you will have to take the panel off to see it. It is white and...
-
If possible you need a zoning system installed, aprilaire makes nice setup
-
-
I would say if it has been working fine for a while, you don't need to adust it, replace it with a new millivolt thermostat gold contacts are better
-
-
Its hard to say, could be vavle. I would start at would contols the vavle, thermostat, control board, don't think zebras
-
First of the year goodman now offers 10 year warranty on all the products standard, ps you can generally 10 yr labor cheap too. I am a goodman dealer
-
I have also , bided any 80% with liner, I think the prices are fair, I would go with the company that brought up the liner issue. I have seen a lot of companies not even bring it up. The water...
-
-
What's the serial # on this 80%eff 75,000 BTU furnace
-
p.s. I had some zoning in a house, the new thermostat had also be wired this way, even though the old one did not. Honeywell zoning
-
With the information given I would say you have a stuck sequencer ( Thermal time delay)
-
Thanks for the help, found problem. It was just on one circuit. Kind of hard to track in a mobile home when it was at least one fixture in every room. Found neutral on a outlet that had a bad...
-
When I say half the house, I did amp checks on all the breakers and three out of the eight 120vac breakers are not pulling any amps. Inside the panel every breaker has 120 vac coming out, I pretty...
-
Half of the house, has no power. I checked everything I thought it was, but not having any luck. I checked boxes where the power is not working for loose neutral, nothing. I have checked for lost leg...
|