Ask Experts Questions for FREE Help !
Ask
    Riles530's Avatar
    Riles530 Posts: 15, Reputation: 1
    New Member
    		  
    #1

    Jan 3, 2016, 11:53 PM
    Rheem gas furnace RGDE 07NMAGR, no induction fan, no l.e.d. on ignition module
    Induction fan will not start when t stat call for heat and the l.e.d. on the hot surface ignition module is not lit, no code, good or bad

    If I manually operate the safety switch behind the lower control panel door, the furnace fan comes on and moves cold air through all the vent for 60seconds and shuts off, same thing happens if I unplug the unit and plug it back in

    I think it is a loose or faulty wire somewhere that I can't find, it's been doing this for a few days again and occasionally when I set the t stat to demand heat, the induction fan starts and the unit goes through the standard start up protocol, the last time I got it to come on, it lasted about 5-6 hours and I'm now back to no heat again
    Riles530's Avatar
    Riles530 Posts: 15, Reputation: 1
    New Member
    		  
    #2

    Jan 4, 2016, 12:17 AM
    on a whim, I replaced the batteries in the t stat and the unit went thru the standard start up protocol and is heating the house fine at this moment, fingers crossed that it's not just a coincidence
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Rheem gas furnace RGDE 07NMAGR, fan comes on but nothing else [ 24 Answers ]

If I turn the power off and restart the unit, the fan comes on but I don't see or hear the igniter and I'm not able to tell if the gas is coming on either, I assume that is a safety feature

Can you adjust Fan Speed on Rheem Criterion 11 gas furnace? [ 0 Answers ]

Craftman gas blower not firing,where ignition-module [ 0 Answers ]

Craftman gas /leafblower not firing,new plug,clean carbon depoist from piston, cylinder bore still not cranking, any ideas?

Furnace ignition module 120VAc [ 3 Answers ]

Hi gents Wondering if you would have any idea of the difference between the ignition module 120Vac and 24 Vac . When you say 120 Vac that means the burner assembly might be HSI and in that case the module should be 120 or that means that is a different technology or what . Appreciate any...

Fan limit settings for a RHEEM Gas Furnace Model 3214-100FB [ 1 Answers ]

I have a RHEEM Gas Furnace Model 3214-100FB. My problem is that when the heat shuts off the fan keeps moving until all the hot air is removed from the vents. The fan then continues to blow until the house becomes cool again, which then causes the heat to have to come back on. What are the proper...

View more questions Search