Ask Experts Questions for FREE Help !
Ask
    rancher's Avatar
    rancher Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 9, 2008, 11:48 AM
    Problems wiring Hunter 44110 thermostat
    I just bought a Hunter 44110 thermostat for an old gas wall heater. Only two wires came out of the wall and were unmarked (even the old thermostat didn't identify + and ground). I have read the instructions and connected one wire to ground and the other wire to RH. Note there is a jumper between RH and RC, it does not seem to turn on if I just connect to RH without the jumper. I have programmed the thermostat to turn on and off at different times of the day, but it only turns on if fan is on (auto never turns it on) and it has to be manually shut off. I have also tried reversing the wires with similar results. Any suggestions how I can make this thermostat work properly?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 9, 2008, 03:26 PM
    You will have to pull a separate power wire or buy a battery powered thermostat. All of this should be in your install papers. One other thing you would be better off tossing the Hunter and getting a Honeywell stat.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Replacing a mercury thermostat for a Hunter Model 44110 [ 3 Answers ]

I have just purchased a Hunter Programmable Thermostat Model 44110. I have taken out the front panel off my old thermostat and notices that my wires are red, white, yellow and green. The panel for the Hunter 44110 has the connections for G, Y, W and the RC and RH have a jumper. What do I do with...

Wiring a hunter 44110 5-2 programmable thermostat [ 1 Answers ]

Am trying to install a new programmable thermostat and I am having problems. My old thermostat had the following wires: white, orange, red, green yellow and blue. The new Hunter thermostat has places for RH, RC, G, Y and W. I have tried several different configurations and cannot get the a/c to...

Hunter thermostat 44110 [ 2 Answers ]

I have hot water baseboard heat, and installed the hunter digital thermostat 44110, and followed the directions as directed, I had had wires W, Y and RH, I marked and installed Each of the wires, and put them where they were marked on the thermostat. I felt well and all of the lights ( temp,...

Hunter 44110 Programmable Thermostat Wiring HELP! [ 3 Answers ]

My current thermostat has the following six wires, hooked as follows: Orange to O Green to G Yellow to Y1 Red to R Black to C White to W1 I am attempting to install the Hunter Programmable thermostat, which only gives me 5 placements for wires:

Thermostat Replacement Honeywell 890121 - Hunter 44110 [ 2 Answers ]

Hi there! Need help to replace an old Honeywell model 890121 with a Hunter 44110 My existing (Honeywell 890121) wiring: Brown - C Green - G Yellow - Y --jumpered to--W Red - R White - O Hunter 44110:

View more questions Search