 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Problem with Central Heat
The way my heater used to work (as it should) I turn up the thermostat, I hear it click on, then I hear the flame ignite, then after it heats up enough the blower kicks on and out comes the heat.
Now to even get it to work, I have to turn the thermostat as high as it goes, even though I hear the click in the thermostat, I never hear the flame ignite. Then the blower kicks on for exactly 20 seconds, then off for exactly 45 seconds, then on for 20 and off for 45, all night long, never changes. When I look inside at the flame, it is always lit, it never goes down to the small pilot light like flame, it's just always on. After 4-5 hours of this the temperature in the house is still only 70 degrees. Any ideas? ** Also is this dangerous like this always being on, it looks pretty hot in there among the flames, like a couple things I see looks like it does when metal gets hot and glows a bit? |
||||
Check out some similar questions!
I have a Rheem electric central heating system that when in the heat mode will not turn on the blower when the thermostat is in the auto position. The heat coils will come on but the blower will not come on unless I put the fan switch on the thermostat in manual position. I am trying to determine...
The ac runs off electricity the heat is gas. The ac worked until around the time it started getting cold. When I switched it over to gas heat it won't heat & the ac doesn't cool now either. Whether its set on auto, on or turned completely off the fan will run continuously I have to cut the power...
Unit blower comes on but no heat the light on control board flashes 4 times pause then 4 times again when system is calling for gas these flashes indicate that a can anyone help? Icannot find reset buttons on my unit.
Central gas heat kicks on briefly but their is no flame
My son's condo has central heat and air, but when the heat setting is put on, there is very little heat being produced. The air coming from the registers is barely warm. Trying to get an idea of what the problem might be. He has installed a new thermostat, but that didn't help at all. Thanks
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
