 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Problem with Carrier Furnace
Carrier Furnace 58MVP080F17114 Displays Trouble Code #42 Was installed in 2003 has run trouble free since install ; Will operate randomly on second stage will sometimes operate on first stage for several hours then go into lockout mode and shuts off gas supply . Sometimes I must cut power supply for 5min to restart. Have checked air intake and exhaust outside;no restrictions. Do you have any suggestions or further checks I can perform to replace defective part or correct the problem
thanks |
||||
Check out some similar questions!
Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?
I have a carrier 58tma furnace and in the past year it has been displaying code 32. Had it cleaned and inspected. Had the circuit board replaced also, which now I tend to think it didn't need to be replaced but tech said it did. After running last winter it displayed the code again and had to hit...
My carrier furnace would only come on if I shut down the main power then turned it back on. Then after it got up to the proper temperature it would shut off but not come back on. Now it won't come on at all. I just replaced the control board and it is doing the same thing.
Carrier furnace model 394JAZ060080AAFA ( about 19 years old) Fan (blower) comes on for two more short bursts after it shuts off during a heat cycle. I tried replacing the thermostat, but this was not the problem. This is not stopping me from getting heat (yet), but it is annoying. Any...
My furnace will not keep running. After approx 10 minutes of normal burning, the burners flame out and then re-ignite over and over again (about 1 second on/ 1 second off) and the gas valve can be heard clicking on and off. If the furnace is allowed to cool and turned back on the process repeats...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
