 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Pilot Sensor
The Furnace pilot is lit and the blower motor runs however, the burners will only stay lit for a few seconds the shut off. The cycle of burners on and off continues with mayby a few minutes in between when they shut off to when they come on again.
|
||||
Check out some similar questions!
97 Nissan Pickup - 160,000 miles - KA24E engine -Check engine Soon Light Code reader says volume air sensor. Is this the same as a mass airflow sensor or the MAP sensor? Where is this sensor located, in the throttle body injection? Just threw a new O2 (Bosch)sensor on it, I lost that bet.. it...
My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...
The car idles randomly after warm up.I check the ecu for codes and it gives 4 crank angle sensor and 8 tdc position sensor. I did a search and one of the ad posted by a guy in Canada says that he had to get part from different vehicles until he got all of them to work properly. Will I be able to...
Have a 25 plus year old furnace pilot will start when signal sent furnace tries to start makes noise as it tries over and over but will not start. Thanks
I have a baso L62AA-5 pilot switch and it used to keep resetting. I would hold the switch down for a good minute and the gas lights, but after a half an hour or so it would go back to its reset position. The standing pilot light was always on and never a problem. After a few days of manually...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
