Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Changed filter and nozzel. Started to bleed and was getting air bubbles, then nothing
[ 0 Answers ]
Have an older (12-15 yrs) Trianco heatmaker with Becket Boiler. It shut off and would not light back up. Has fuel, changed filter and nozzel and cleaned the eye. I then started bleeding. Got bubbles for a few seconds and then nothing. It appears not to be getting fuel. Any suggestions?
Becket oil furnace burner
[ 1 Answers ]
Westinghouse nordyne oil furnace model 04md-091a-12-fa ran out of oil, refilled oil tank and bled out. It lights runs for about ten minutes and trips out, it re starts for 3 or 4 times, runs for about 5 minutes, then locks out. I bled it some more but it doesn't get better, what could it be?
Becket AFG Burner Ignition
[ 7 Answers ]
My burner sometimes fails to light in morning after set back thermostat calls for heat. My service man checked pump pressure 100psi+and transformer, changed nozzle and electrodes. Unit still would not fire untell transformer raised. I believe this reduced air flow, unit fired and continued to...
Fuel oil nozzel
[ 2 Answers ]
Can a .85-80H nozzel be used to replace a .85-80B Noxxel? Thanks Dennis
Spray nozzel, the wand of power washer does not shut off
[ 1 Answers ]
The wand on my electric power washer does not shut off when I release the handle. Occasionally if I turn the pressure control on the end of the wand to low it will shut off. View more questions Search
|