Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
System goes into aux heat
[ 1 Answers ]
Replaced really and system goes int to aux heat
Hydronic heat system
[ 5 Answers ]
I have a 21 unit builiding with a hydronic heat system with zone valves in each unit. Hot water flows slowly in the unit I am in but does not respond to thermostat. Old low voltage thermostat had three wires green red and yellow. Old thermostat was connected with green to the R terminal Red to...
More Heat from Hot air system
[ 4 Answers ]
I have a forced hot air heating system. House is a small cape. About 1500 SF living area. I. use about 550 Gallons of heating oil in a season. With oil at $4.50 per gal.I want to try to squeeze more efficiency out of the system. Furnace is 24 years old. I know the new burners have a pre and post...
NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue.
[ 11 Answers ]
I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -
System calling for heat but no response from system
[ 1 Answers ]
My thermostat is set to 25 which is higher than the current temperature but my heating system is not firing up.. we have hot water - the boiler is a Micron - the heating timer is set to "on" on the program setting, and so is hot water which is fine but we have no heating, it was on earlier and went... View more questions Search
|