Ask Experts Questions for FREE Help !
Ask
    tom855's Avatar
    tom855 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jun 4, 2015, 03:57 PM
    Low voltage fuse in a\c
    The 3A fuse in my Air Handler blows
    bitters's Avatar
    bitters Posts: 348, Reputation: 12
    Full Member
    		  
    #2

    Jun 4, 2015, 04:03 PM
    Well, there has to be a short some where. First check the stat cable outside where it comes from the house to the outside unit.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #3

    Jun 5, 2015, 08:32 AM
    Without a meter, fuses can used to troubleshoot. Replace fuse and try just Fan, if it doesn't blow fuse, Try heat. That engages Heat and Blower. If it doesn't blow, it is likely the wiring to outside compressor. Try Cool, If it blows, as mentioned above and is most likely culprit. Could be either the low voltage control wiring to compressor, or shorted windings on the Compressor Contactor Coil. Follow wires and look visually for any shorts. Many ways to trouble shoot from here. Disconnect wires at contactor and try again. With a meter you can verify no short on control wires or a shorted coil.
    Good Luck
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

CHALLENGING QUESTION: Low-voltage switch in a high-voltage circuit? [ 6 Answers ]

A project I'm working on has an air pump and a water pump that run during operation. When the water tank that the water pump draws from becomes empty, a liquid level switch will be used to shut off both pumps. The original plan was to just place the switch in series with the power supply for...

I have low voltage one one of the 120 line of a 240 voltage supply why? [ 3 Answers ]

I have 240 supply coming from my supplier. 3 wires 120 volts , 120 volts, and neutral. As soon as I turn on my breaker one of the 120 line goes low to something like 65 volts and the other lines goes high to 170 volts. Why is that?

Why hrc fuse not used for low voltage circuits ? [ 1 Answers ]

HRC fuse is generally used for medium voltage circuits,what are the reasons for not using it in low voltage circuit.

Halogen - line voltage (120v) or low voltage (12v) [ 5 Answers ]

Hi. I am renovating the kitchen and plan to install small halogen MR16 ceiling pot lights. Contrast and Lightolier have been recommended. At least, the Contrast line is available with either line or low voltage feeds. These questions come up as the plan calls for 9x35w MR16 (ceiling pot...

Track lights: low voltage vs line voltage.comsume the same electricity in the end? [ 11 Answers ]

Hi! I just installed a section of track light in my living room just to see what it would look like and so far I'm not convinced... you see, I had a regular celing lamp with a 75w incandescent bulb and the room was very well lit... now with the track light I find that I need 3 fixtures with halogen...

View more questions Search