Ask Experts Questions for FREE Help !
Ask
    taylorN12's Avatar
    taylorN12 Posts: 2, Reputation: 1
    New Member
     
    #1

    May 30, 2013, 12:48 PM
    Looking for help with the Honeywell Chronotherm IV Plus Thermostat
    This morning I woke to a warm downstairs area. I walked over to the thermostat and noticed the display was blank. After various Internet searches and locating the User manual for this model, I found this website. The user manual troubleshooting guide addresses six (6) possible symptoms and the remedy to the problem. I've ruled out 1) checking if the thermostat is mounted and latched, 2) checking if the circuit breaker was tripped, and 5) checking the wiring between the thermostat and HVAC equipment. The 3rd & 6th symptoms, 3) checking if the fuse is blown--replace the fuse, and 6) If 24 Vac is present, proceed with troubleshooting cannot be resolved because I don't know where the fuse is located on the thermostat nor do I understand what 24 Vac is present, proceed w/troubleshooting means. Can you help me?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
     
    #2

    May 30, 2013, 02:19 PM
    Fuse is located on the control board or on the transformer, usually located on the air handler with the on/ off switch. In order to check 24VAC, you will need a multi tester, also known as a VOM.. Know how to use one? Does this tstat have a battery?
    taylorN12's Avatar
    taylorN12 Posts: 2, Reputation: 1
    New Member
     
    #3

    May 31, 2013, 09:10 AM
    Thanks for your help! The tstat does not have batteries and will use the VOM on the 24VAC area. Thanks again!

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Honeywell Chronotherm IV Plus Thermostat [ 8 Answers ]

How do I clear the flashing filter light on my thermostat? I have changed my filter.

Honeywell thermostat chronotherm I've plus [ 1 Answers ]

How do you get the thermostat to stay at a certain temp all the time? I set it but then it goes down at night...

Honeywell Chronotherm Thermostat [ 1 Answers ]

I have a Honeywell Chronotherm III Thermostat. After, 5 years of use, the batteries finally went dead. Changed the batterries, and the thermostat is not working. How do I restart the thermostat, so that I get heat?

Honeywell Chronotherm IV Plus thermostat [ 1 Answers ]

On a Honeywell Chronotherm IV Plus remote thermostat, how do you clear the flashing filter? Thanks. Charles

Honeywell Chronotherm IV Plus Honeywell Thermostat, T8624D [ 1 Answers ]

Honeywell Deluxe Programmable Multistage Thermostat, #T8624D Chronotherm IV Plus I have 2 of above thermostats and have had for about 5 years. It takes no batteries and is directly connected to a 24 volt source. Have one upstairs and one downstairs. Have noticed at times that the LCD on...


View more questions Search