Ask Experts Questions for FREE Help !
Ask
    jak's Avatar
    jak Posts: 6, Reputation: 0
    New Member
    		  
    #1

    Nov 25, 2006, 09:05 AM
    Lennox oil furnace
    What is the proper procedure for cleaning a oil furnace, such as cleanouts to heat exchangers and where could I find a exploded view of a lennox oil funace
    leftwinga's Avatar
    leftwinga Posts: 54, Reputation: 3
    Junior Member
    		  
    #2

    Nov 25, 2006, 08:06 PM
    Don't Know About The View.. but One Must Find Any And All The Cleanouts And Do That... clean Em Out. Properly Seal Them Once Done. Remove Smoke Pipe Then Brush Out And Clean Out Chimney Base Too. Then Do N-of-pg... oil Motors And Such. But With Out Tools You Won't Be Able To Set Burner Up To Peak Eff.
    jak's Avatar
    jak Posts: 6, Reputation: 0
    New Member
    		  
    #3

    Nov 26, 2006, 07:48 AM
    n-to-pg ?
    leftwinga's Avatar
    leftwinga Posts: 54, Reputation: 3
    Junior Member
    		  
    #4

    Nov 26, 2006, 08:01 AM
    Sorry.. nozzle.. oil filter.. pump gasket
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Lennox Furnace schematics [ 5 Answers ]

Hi, I need the wiring schematic for a Lennox forced air gas furnace Model #CH7D-51M. Thanks.

Lennox G12 furnace [ 3 Answers ]

Hello, My daughter has an old Lennox G12 furnace and the pilot light went out. I know this should be a simple task to relight, but we are not sure where the pilot light is and don't want to just stick a live flame in to "search" for it. Thanks, Chele

Wiring for older lennox furnace [ 2 Answers ]

I have an older Lennox furnace that had some wires melted in a flash fire. Does anyone know where I might get the wiring schematics to rewire the unit? When I went to move the wires they broke apart and know I want to ensure that they are connected properly again. The model is G8R-120-1, serial...

Lennox Oil Furnace Problem [ 12 Answers ]

My mom has an oil fired furnace that just stopped working. I replaced the transformer(white rodgers) that has the connections for the Thermostat,flame detector,etc. That didn't fix the problem. I have hit the reset button and that doesn't work either. At one point,I rotated the Fan Limit switch...

Oil Burner Furnace [ 1 Answers ]

The problem goes like this. Thermostat calls for heat, burner starts and runs for a minute or so and shuts off. After burner shuts off, the blower starts and the burner starts again until the thermostat reaches temp and the burner shuts off blower contiues to run until the low temp limit is...

View more questions Search